Advertenties
Beschikbare talen
Beschikbare talen
If you have selected the "Outputs Output Polarity = Negative" menu item:
Output status
Deactivated
Activated
If you have selected the "Outputs Output Polarity = Positive" menu item:
Output status
Deactivated
Activated
If you want to trigger an external device with the voltage potential of the
output only in terms of potential, wire the output as shown in the above
example wiring diagram. The resistor R should have a value of approx. 1 kΩ.
You will then have the following potentials at point "X":
Output status
Deactivated
Activated
In the programming menu, you can separately set whether each of the four
outputs takes on a negative or positive potential when activated.
10. Putting into operation
Once all necessary connection work has been completed, close the housing.
Details can be found at the beginning of Section 9 (Installation).
Status of the external device, e.g.
LED
OFF
ON
Status of the external device, e.g.
LED
ON
OFF
Menu setting:
Output Polarity =
Positive
Negative
Positive
25 UK
Menu setting:
Output Polarity =
Negative
Positive
Negative
Advertenties
