Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. Put the door on a soft cloth on a stable surface.
5. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
2
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides
out of the supports completely.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
16
All manuals and user guides at all-guides.com
1
8. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the glass
panel and the oven door. Do the above steps in the
opposite sequence.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you install the internal glass panel in
the seats correctly.
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
A
Advertenties
Inhoudsopgave
Probleemoplossen
