Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The bus cable must be selected according to the country specific rules, where the values which
are included in the technical data must be adhered to.
Cable type
Application
YCYM
Fixed system
J-Y(st)Y
Fixed system
JH(st)H
Halogen-free cables,
Remote system
A-2Y(L)2Y
Telephone ground cable,
A-2YF(L)2Y
System in outside area
3.4 Mounting and installation
For the correct mounting and connection of the OptiTherm+ to the air heaters, you follow the
points below:
Check that the electricity supply is switched off. If that is not the case, then first switch off
•
the electricity supply before you proceed. For this, also consult the technical manual of the
air heater to be connected.
Mount the OptiTherm+ on the partition, taking into account §3.2 Placing the OptiTherm+
•
Only applicable when external sensors are applied:
•
Mount the external sensors at the correct place. For this, also consult the instruction which
is delivered with the sensor.
Lay the correct cabling between the air heater and the OptiTherm+ and, if applicable, the air
•
heaters with each other. For this also take into account §3.3 Cabling. [2][3]
Only applicable when external sensors are applied:
•
Lay the correct cabling between the air heater and the external sensor. For this also take
into account §3.3 Cabling and the instructions for the external sensor. [2][4]
Connect the OptiTherm+ and the air heater(s) according to the diagram [2][3]
•
Only applicable when external sensors are applied:
•
Connect the cable to the external sensor and the air heater and there also take into account
the instructions for the external sensor. [2][4]
Only applicable with the connection of more than one appliance on 1 OptiTherm+:
•
Install the Dip switch and switch S4 on the automatic burner of the air heaters. For this,
ensure that the air heater to which the OptiTherm+ is connected is always addressed as
appliance 1. [5][6]
When you are ready with the installation and connection, you can start to operate the
OptiTherm+ and the air heater(s). For this, also consult the technical manual of the air heater.
6
EIB specification
Dry, damp, wet rooms
In the open air (no direct exposure to
sunlight)
Face-fit, flush-fit, in conduits
Only in interior spaces
Face-fit, in conduits
Advertenties
Hoofdstukken
Inhoudsopgave
