4.3 Frost protection
The OptiTherm+ is supplied with a frost protection function. This means that when the room
temperature falls below the set frost temperature, the air heater(s) are automatically switched on.
That is also the case when the heating mode is not switched on. The frost temperature is set as
standard at 5°C, you can change that, if you wish, for that see §5.2 change temperature setting.
0
9
05.0 °C
08:00
01-03-2011
4.4 Switch heating mode on/off.
To switch the heating mode on or off, you push the button "heating".
1
2
05.0 °C
08:00
01-03-2011
The flame symbol will now appear on the display so that you can see that the heating mode is
switched on. With heating request, the status bar will also appear on the display.
4.5 Switch ventilation mode on/off.
To switch the ventilator of the air heater on or off, you push the button "ventilation".
The ventilator symbol will now appear with I or II on the display so that you can see that the
ventilator is switched on.
Note!
The ventilation mode can be used at the same time as the heating mode. So if you wish during
heating mode you can have the ventilator running continuously.
4.6 Switch overtime timer on/off
When you want to switch to another operation mode outside the program switch times you can
make use of the overtime timer. See the image below:
1 6.0
15.0 °C
01-03-2011
–
Switch on overtime timer
Every time this button is pushed in, the time duration is increased by 15 mins.
–
Switch off overtime timer
As standard, the overtime timer will switch the OptiTherm+ to the day temperature The
maximum time duration is 3:00 hrs. The settings can be changed in the settings menu: §5.7
overtime timer
10
0 .
0 .
17:00
1x = 00:15
2x = 00:30
3x = 00:45
enz...
:
:
0 4.0
05.0 °C
08:00
01-03-2011
1 2.0
18.0 °C
17:00
01-03-2011
hold
± 3sec.
1 6.0
18.0 °C
17:00
00:15
01-03-2011
press in
button or increase the time duration.
keep
button pushed in until the symbol
time remaining disappear from the screen
and the