Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
14. Change of crystal
In order to avoid a double channel assignment it may be necessary to change the crystals on your remote control
system. For this purpose, proceed as follows:
• For reasons of operational safety, you should only use crystals that are explicitly recommended for the use of your
remote control system by the supplier.
• While the transmitter is turned off, remove the cover (1) of the
transmission crystal from the rear of the transmitter housing (2).
• Take the transmitter crystal out of the transmitter housing.
• Insert the replacement crystal (3) with a different channel in the same
frequency band. Make sure, you fit the correct quartz in the retainer.
Transmitter crystals are normally marked with the letter T or TX (T =
"transmitter").
• Then replace the cover of the transmitter crystal (1) on the transmitter.
• While the receiver unit is switched off, pull the receiver crystal (4)
with the safety ring (5) from the receptacle of the receiver.
• The suitable crystal for the receiver has to be marked with the same
channel number as the transmitter crystal. In addition it is marked
with the letter code R or RX (R = receiver).
• Pull the safety ring (5) off the receiver crystal and slide it onto the
replacement crystal (6).
• Insert the replacement crystal (6) with the suitable frequency for the
transmitter including the safety ring into the receiver.
• Next, switch on the transmitter and then the receiver and check the
system for correct functioning.
58
All manuals and user guides at all-guides.com
Figure 24
Advertenties
Hoofdstukken
Inhoudsopgave
