Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Start-up / Changing the bulb / Maintenance and Cleaning / Disposal
Start-up
Mounting the light
Note: Two people required for assembly.
Note: When assembling the support tube, be sure
not to damage the mains lead
Loosen the lock nut
Pull the upper support tube
support tube
.
6
Tighten the lock nut
Secure the joint using the socket screw (small)
and the socket head wrench (small)
Now screw the upper support tube clockwise
into the lower support tube
Carefully pull the mains lead
support tube.
Screw a snap ring
9 a
(large)
.
9
Push the socket screws (large)
base
from below.
8
Place the decorative disc
screws from above.
Secure the support tube to the base
socket head wrench (large)
Remove the lamp ring
socket
.
1
Place the fabric lamp shade
and secure the fabric lamp shade
lamp ring
.
3
Use a lint-free cloth when installing the lamp
Insert the E27 bulb
clockwise to secure.
Adjust the lampshade
Plug the connector into a socket that has been
professionally installed.
Note: The heavy net weight of the fabric lamp
shade
greatly limits lateral positioning of the
2
fabric lamp shade
Your light is now ready to use.
Switching the light on / off
Switch the lamp on or off using the ON / OFF
switch
.
11
inside the lamp.
10
.
5
out of the middle
4
to secure the joint.
5
.
13
.
7
out of the
10
onto each socket screw
through the
9
over the socket
9 b
using the
8
.
14
from the lamp
3
over the socket
2
using the
2
into the socket and turn
15
to the desired position.
2
.
2
Changing the bulb
CAUTION! RISK OF ELECTRIC SHOCK!
When replacing the illuminant, first disconnect the
light from the mains. To do so, remove the fuse or
switch off the circuit breaker in the fuse box
(0 position).
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the light to cool down
completely.
Only replace the lamp once it has completely
cooled down.
12
Use a clean, lint-free cloth when replacing the
bulb
.
15
Turn the defective bulb
the bulb socket.
Only use LED illuminants
output of 7 W and E27 base.
Insert the new bulb
turn it clockwise to tighten it. Ensure that it is
positioned correctly.
Reinsert the fuse or switch the circuit breaker
back on.
Maintenance and Cleaning
SHOCK! First unplug the mains plug from the socket.
CAUTION! RISK OF BURNS DUE TO
.
HOT SURFACES! Allow the lamp to cool down
15
completely.
SHOCK! For electrical safety, never clean the light
with water or other liquids, or immerse it in water.
Do not use solvents, benzene or similar sub-
stances. They could damage the light.
Only use a dry, lint-free cloth for cleaning.
Disposal
The package and packaging materials
consist entirely of environmentally friendly
materials. They can be disposed of at your
local recycling facility.
anticlockwise out of
15
with a maximum
15
into the bulb socket and
15
DANGER OF ELECTRIC
DANGER OF ELECTRIC
GB/IE/NI
7
Advertenties
Inhoudsopgave
