Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Safety / Initial use / Care and cleaning
Do not kink the mains lead or run it over sharp
edges.
Do not use the mains lead as a carrying handle.
Working safely
Install the light so that it is protected from
moisture and dirt.
Prepare carefully before assembly and allow
yourself enough time. Lay out all the individual
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
In order to disconnect the lamp completely from
the power supply, the mains plug must be re-
moved from the socket.
Initial use
Assembling the light
Model no.: 14142605L
Assemble the lamp head by screwing the tubes
to the screw threads
6
Note: Be sure to screw in the tubes
as possible so that the light is stable.
Loosen the lamp ring
Place the lamp shade
Screw the lamp shade
ring
.
2
Use a clean, lint-free cloth to insert the bulb
Screw the bulb
1
socket
.
4
Plug the mains plug into a properly installed
socket.
Verify it is seated correctly.
Model no.: 14142505L
Loosen the lamp ring
Place the lampshade
Screw the lampshade
ring
.
2
8
GB/IE/NI
of the lamp head.
7
as far
6
from the lamp socket
2
onto the lamp socket
3
tightly onto the lamp
3
clockwise into the lamp
from the lamp socket
2
onto the bulb socket
3
tight using the lamp
3
Use a clean, lint-free cloth to insert the bulb
Screw the bulb
socket
.
4
Plug the mains plug into a properly installed
socket.
Verify it is seated correctly.
Your light is now ready to use.
Switching the light on / off
Use the in-line switch to turn the LED light on
and off.
Changing the bulb
SHOCK!
First unplug the mains plug from the socket.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the light to cool down completely. Only replace
the lamp after it has completely cooled off.
Use a clean, lint-free cloth when replacing the
bulb
.
1
Turn the defective light bulb
out of the lamp socket
Only use LED light bulbs as specified in the
.
chapter "Technical data".
4
.
Insert the new light bulb
4
and turn it clockwise to tighten it. Ensure that
4
it is positioned correctly.
.
Plug the mains plug into the socket again.
1
Care and cleaning
First pull the mains plug out of the mains socket.
.
For electrical safety reasons, never clean the lamp
4
.
with water or other fluids nor immerse it in water.
4
clockwise into the lamp
1
DANGER OF ELECTRIC
anticlockwise
1
.
4
into the lamp socket
1
RISK OF ELECTRIC SHOCK!
RISK OF ELECTRIC SHOCK!
.
1
Advertenties
Hoofdstukken
Inhoudsopgave
