Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
NOTE
• Check for leaks during the first wash. If leakage occurs, check that the drain hose is connected correctly and completely. If
there is no leakage, the drain hose is connected correctly.
3.7.2. CONNECTING THE DISCHARGE HOSE TO A DRAIN PIPE
Insert the discharge hose into the drain pipe.
Do not insert the discharge hose deeper than 15 cm into the drain
pipe to prevent the water from flowing back during pumping.
3
NOTE
• If you want to connect the drain hose of the washing machine and a dryer to the same drain pipe, first install a y-piece on
the drain pipe.
• The loose drain pipe must have a minimum diameter of 4 cm and be present at a maximum height of 100 cm.
• It is advisable to attach the discharge hose to the wall with a hose bracket to prevent kinks or blockages in the discharge
hose.
3.8. LEVEL THE APPLIANCE
1.
Carefully slide the appliance into place.
2.
Place a spirit level on top of the appliance to check that the
appliance is level.
3.
If the appliance is not level, adjust the adjusting feet to level
the appliance:
a.
Loosen the adjusting foot bolt with an M17 spanner.
b.
Turn the adjusting foot in or out.
c.
Tighten the bolt again.
The maximum height of the adjusting feet is 5 cm.
3.9. TO CALIBRATE THE APPLIANCE
1.
Check that the drum is empty.
2.
Insert the power cable into the earthed socket.
3.
Press and hold the Standby button until the control panel lights up.
4.
Press and hold the accelerated programme button and temperature button until t19 appears on the control panel.
5.
Press the start/pause button.
The appliance is calibrated. When the appliance is ready, **** will appear on the control panel.
45
Advertenties
Hoofdstukken
Inhoudsopgave
