Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
14.2 Aligning the exhaust flap
Do not completely close the exhaust
•
flap at the air discharge opening
under any circumstances while you
are operating the dehumidifier.
You can align the exhaust flap (1) at
•
the air discharge opening in 5 stages
(small opening to maximum
opening) in order to guide the air
that is being discharged in a certain
direction, e.g. towards laundry that
is being dried (see figs. A and C).
14.3 Using the timer function
The dehumidifier possesses a timer
function, with which you can pre-set the
desired running time (in hours). Upon
expiration of the operating time the
dehumidifier will switch itself off
automatically.
1. Press key 21 (see fig. C) The
running time that was set most
recently will blink in the display.
2. While the display is blinking, you can
set the running time as described in
step 2.
3. If you make no adjustment,
4. the display will change back to the
current air humidity.
5. Press the key + or - once or several
times, in order to set the running
time (in hours).
6. For a few seconds the adjusted
running time will blink in the display.
7. Subsequently, the display will
change back again to showing the
current air humidity.
8. The control light above the Timer
button 21 (on) is lit up constantly
while the timer function is active.
9. Press button 21 in order to have the
remaining running time of the timer
function displayed.
10. The remaining running time will
blink in the display. After a few
seconds the display will change back
again to show the current air
humidity.
11. Press button 21 a second time while
the remaining running time is
blinking in the display in order to
switch the timer function off before
the set time period has expired.
Page | 24
CAUTION
Danger of damage!
If the dehumidifier is handled
improperly, you can
damage it.
14.4 LED panel
Slight deviations (approx. 3 %) in the
indicated values are possible. That
means that the LED panel will already
change colour if the air humidity is 3%
lower or higher than indicated.
In this way a permanent change of the
lighting colour ought to be avoided. LED
panel 5 at the front of the dehumidifier
shows the degree of the air humidity in
the environment of the dehumidifier
(see fig. A):
The LED panel lights up:
• in blue if the relative air humidity is
slight in the environment (under 50%).
• in green if the relative air humidity in
the environment is in the medium range
(approx. 50–70 %).
• in red if the relative air humidity is
high in the environment (above 70%).
15 Operating modes
If there is a change in the operating
mode or interruptions in operation, the
exhaust stage is implemented/activated
immediately during the dehumidifying
process and will possibly only run again
with a delay of approx. 3 minutes to
prevent overheating of the dehumidifier
or of the compressor.
A tolerance of approx. 3% must be
factored into the air humidity values
indicated. That means that D. h. the
dehumidifying function switches off if
the air humidity is approx. 3% under
the set value and switches on again if
the air humidity is approx. 3% above
the set value.
Advertenties
Inhoudsopgave
