Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Note: weekly will still work as per setting even under APP powering off state.
6.
is countdown function for setting to power off the heater.
Note: APP powering off will cause timer setting canceled.
means convert temperature display between ℉ and ℃
7.
Note:Weekly, Timer and TEMP these three functions can be edited only under power
on mode!
8.
means other editing of the heater, description as below.
1)
Device name: edit the thermostat name.
2) Device information: to check the virtual ID etc device information.
3) Share device: you can share the control of this thermostat to other mobile numbers/email
addresses if they have been registered in "Smart Life" APP.
4) Create Group: you can group different thermostats to control together.
5) FAQ & Feedback: to report any problems to the APP supplier.
6) Add to the home interface: you can turn on the heater directly on the home interface.
7) Check Device network: check the wifi connection status of device.
8) Check Update: Get latest firmware version.
9) Remove Device: remove thermostat from your APP.
Ⅷ. Important note
1.
The heater only support 2.4GHz network.
2.
Red light means the heater is online, blue light means the heater is powering on.
3.
If long press Wi-Fi reset button 5-10s or repeat powering on/off the heater 4 times by plug,
internal WiFi connecting information will be cleared, you need to pair WiFi again.
4.
Thermostat disable switch on means disabling thermostat.
5.
WiFi or network disconnected will cause heater offline and heater powering off.
6.
The blue LED indicator may not light up at the first time when you finished the WIFI
connecting, you need to wait for a couple of seconds due to network searching and
connecting.
7.
Alkaline battery is recommended for the remote control. Please remove the battery if long
time no use.
8.
If the remote can not turn on the heater, please check if the setting temperature is not high
above the room temperature.
9.
Put the remote-controller at most 8 meters from the heater.
Do not mount the remote-controller close to any cold or heat source;
Do not cover the remote-controller;
Do put it in an open normal room environment rather not inside a drawer/pocket etc, or
under pillow/quilt etc.
10.
Do not use heaters in wet or running water environment.
11.
Please pull out the heater power supply from your socket if long time no use.
12.
Both the remote-controller and App can turn on/off the heater and set the temperature.
The remote-controller setting can be linked to the App, but the App setting cannot be
linked to the remote-controller.
13.
If the connection between remote and the built in receiver breaks and the temperature
24
25
85
Advertenties
Inhoudsopgave
