does not mean that the remote-controller has stopped working. It is still detecting real-
time temperature data and sending the real-time temperature data to the receiver every
60s for logical control (the remote-controller will send the collected temperature data
whether it is on or off).
7. One remote-controller can be paired with several heaters, users can pair them one by one
or at same time together, both ways are workable.
Ⅴ. Instructions of remote-controller operation
1. Power on the heater , and then press " " and "+" at the same time within five minutes
to start pairing , the WIFI symbol flashes three times and sends out the paring code to
indicate that paring is taking place, there will be one beep sound from heater after success.
Note:1.Please turn off the heaters that you do not want to be paired before pairing .
2.If the remote control needs to be replaced, please power on the heater again, and
then complete the pairing within five minutes. If the pairing is not finished within
five minutes, the pairing mode will be off and you will need to repeat the above
steps to pair again.
2. Press " " to turn on the heater, and press again to turn off the heater.
3. Press the "+" key to increase the set temperature by 1℃, press the "-" key to decrease
the set temperature by 1℃, and hold the "+" key or the
"-" key for 3 seconds to increase or decrease the set temperature continuously.
4. Press the "+" and "-" key at the same time to switch the temperature unit between ℃
and ℉.
5. Press the " " key and the "-" key at the same time for 3 seconds to open the child lock
mode, do so again to close.
6. SET means the target temperature. This is heating symbol.
1) If the SET temperature is lower than the ROOM temperature, the heating symbol is not
displayed.
2) If the SET temperature is higher than the ROOM temperature, the heating symbol is
displayed.
3) When the room is heated to the SET temperature, then the remote control will stop
displaying the heating symbol.
Remote-controller
20
81