Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GX4 GAS MONITOR
MAINTENANCE CONTINUED
FIGURE 11.5
After removing the manifold, inspect it from
all sides to make sure all of the holes are
clear and that there is no oil or debris inside
of the tube. DO NOT DISASSEMBLE THE
MANIFOLD. If there is oil or debris inside of
the manifold a replacement manifold (P/N:
08-422) must be used.
FIGURE 11.7
Rotate the manifold into the back of the
monitor so the clip goes into the notches
on the back of the monitor making sure it is
securely clipped in with an audible "click".
26
®
FIGURE 11.6
To replace the manifold, insert the tapered
end into the green ring of the push-lock
fitting inside the back of the monitor. Orient
the holes in the manifold towards the
sensors.
REPLACE MOUNTING BRACKETS
If the Mounting Brackets (P/N: 08-425)
break, you can replace them by removing
the two screws securing each bracket.
Remove the broken bracket and replace
with a new bracket. Secure the new bracket
with the provided (UNC 10-24 x ¾") screws.
FIGURE 12.1
Advertenties
Inhoudsopgave
