Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
shock with an external battery, follow the below electrical and battery precautions and
procedures.
WHEN USING A BATTERY:
FIGURE 5.2
1
+
and is recommended for use with 12V batteries as well. Consult your automotive or industrial
electrician for help with convertor selection and setup.
To avoid startup power surges while using Battery Clips (08-431), only connect the battery
clips when the vehicle or compressor is already running. Connect in the following order:
1.
Red = +12V to the positive terminal of the battery.
2.
Black =
If connecting to a vehicle or a compressor: connect the black clip to a bare metal ground
location on the vehicle or compressor.
If connecting to a battery only: connect the black clip to the negative terminal of the
battery.
Be sure to keep the GX4
Exhaust fumes can interfere with the measurements of the sensors, particularly when the air
supply is not yet connected.
WARNING
Explosion Hazard
Batteries emit explosive gasses during normal operation.
Keep sources of ignition away.
Work in a well-ventilated area
Avoid contacting/bridging terminals with metal objects - this can create sparks and
ignite gasses.
To reduce the risk of battery fire or explosion or of fire or electric
2
-
as far away from the car, truck, or compressor exhaust as possible.
®
Refer to battery manufacturer and equipment manufacturer's
instructions.
Battery clips can be used on most 12V
batteries, such as on a car or truck, or on a
compressor. GX4
devices exposed to high
®
voltages will be permanently damaged and
will not be covered under the warranty.
Surges on some equipment (particularly
during startup/shutdown) can cause
extremely high voltages. Do not connect
the GX4
directly to 18V or 24V batteries. If
®
you must connect to a battery higher than
12V, RPB
highly recommends using an
®
appropriate DC-DC converter. A converter
will also help protect against power surges
15
Advertenties
Inhoudsopgave
