Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GX4 GAS MONITOR
SETUP AND OPERATION CONTINUED
shock with the charger, follow the below electrical and battery precautions and procedures:
FIGURE 10.1
Plugged In/
Charging
Before plugging in:
Inspect the charger and power cords before use. Replace if any parts are damaged. Do not
substitute, modify or add parts to the chargers. Do not attempt to service the chargers. There
are no user-serviceable parts inside.
Use only the provided charger and cord.
Where to plug in:
Plug in only:
indoors,
in a dry area,
away from sources of heat,
away from anything that can burn if exposed to heat or flame,
in a well-ventilated place,
where the unit can be monitored and easily observed.
Charging
The Power Supply is a universal 110-240 volt adaptor. The batteries are manufactured to last
350 charge cycles for peak performance. Full charging cycles take 4 hours.
Battery Care
Do not USE the unit outside the recommended temperature limits 14° F to 140° F
(-10° C to 60° C).
Do not CHARGE the unit outside the recommended temperature limits 32° F to 113° F
(0° C to 45° C).
Do not STORE the unit outside the recommended temperature limits 14° F to 113° F
(-10° C to 45° C).
Do not disassemble. Do not immerse in water or other liquids.
Battery and Charger Care
Use only the 08-430 Power Supply with correct region specific plug.
If the unit or power supply gets excessively hot, discontinue use and allow them to cool.
Disposal
This unit contains a battery pack. Dispose of battery packs according to local regulations. Do
not crush, disassemble, dispose of in standard waste bins, in a fire, or send for incineration.
Failure to properly dispose of battery packs may lead to environmental contamination, fire or
explosion. If you have any questions, ask your employer.
24
®
To reduce the risk of battery fire or explosion or of fire or electric
Fully
Battery
Charged
Low
Note:
The unit requires 10 seconds to read the
battery level after the unit is turned on.
Advertenties
Inhoudsopgave
