Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GX4 GAS MONITOR
SETUP AND OPERATION CONTINUED
Each monitor comes with 3 blank
cartridges. These should be placed into
slots that are not currently being used
to protect the contacts and air supply
manifold.
FIGURE 9.2
Lift the edge of the cartridge to remove it
fully from the monitor. Replace with a new
cartridge or a blank sensor cartridge.
20
®
FIGURE 8.5
REMOVE CARTRIDGE
To remove a cartridge, press the
corresponding release button and the
cartridge will "pop up".
When the cartridge is removed, a Warning
will display on the screen. It will alarm after
a countdown if the warning is not cleared
before the countdown ends. Press the
button below the word "REMOVE" and then
confirm that the cartridge has been removed
on the next screen by pressing the button
below the word "OK" on the screen. Turning
the unit off will not clear this Warning. The
Warning will reappear when the unit is
turned back on and it can be cleared at that
time.
FIGURE 9.1
Advertenties
Inhoudsopgave
