12. TROUBLESHOOTING
WARNING!
Improper repair of the appliance may
pose a danger to the safety of the user.
Any repairs must be performed by
qualified personnel.
The majority of problems that may occur
can be solved without the need to contact
an Authorised Service Centre.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with wa‐
ter.
•
The lights related to MY TIME
selection bar flash 1 time inter‐
mittently.
•
An acoustic signal sounds inter‐
mittently.
The appliance does not drain the
water.
•
The lights related to MY TIME
selection bar flash 2 times inter‐
mittently.
•
An acoustic signal sounds inter‐
mittently.
11.7 Cleaning the upper spray arm
Do not remove the upper spray arm. If the
openings in the spray arm are clogged,
remove the remaining particles of soil with a
thin pointed object, e.g. a toothpick.
Refer to the below table for information on
possible problems.
With some problems, the lights related to
MY TIME selection bar flash intermittently to
indicate a malfunction and the alarm code.
Possible cause and solution
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of the
countdown.
•
The appliance recharges the resin inside the water softener. The dura‐
tion of the procedure is approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For this
information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the interior filter system is not clogged.
•
Make sure that the drain hose has no kinks or bends.
ENGLISH
47