Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Water softener level
3
4
5
6
7
8
9
10
In case of the high water softener setting, it
may occur also in the middle of the
programme, before the rinse (twice during a
programme). Regeneration initiation has no
impact on the cycle duration, unless it occurs
in the middle of a programme or at the end of
a programme with a short drying phase. In
such cases, the regeneration prolongs the
total duration of a programme by additional 5
minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin in the
same cycle or at the beginning of the next
programme. This activity increases the total
water consumption of a programme by
additional 4 litres and the total energy
consumption of a programme by additional 2
Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more
than one in the same cycle) may prolong the
programme duration by another 5 minutes
when it occurs at any point at the beginning
or in the middle of a programme.
All the consumption values mentioned in
this section are determined in line with
the currently applicable standard in
laboratory conditions with water hardness
2.5mmol/L (water softener: level 3)
according to the regulation: 2019/2022 .
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
36
ENGLISH
Amount of water (l)
62
47
25
17
10
5
3
3
How to set the water softener level
Make sure the appliance is in user mode.
1. Press
.
• The indicator
• The remaining indicators are off.
• The display shows the current setting:
e.g.
= level 5.
2. Press
repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
7.3 The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the final rinse.
When the rinse aid chamber is empty, the
rinse aid indicator turns on. If the drying
results are satisfactory while using multi-
tablets only, you can deactivate the
notification for refilling the rinse aid. However,
for best drying performance, always use rinse
aid.
If standard detergent or multi-tablets without
rinse aid are used, activate the notification to
keep the rinse aid refill indicator active.
How to deactivate the rinse aid empty
notification
Make sure the appliance is in user mode.
1. Press
.
• The indicator
• The remaining indicators are off.
• The display shows the current setting.
–
= the rinse aid empty
notification is deactivated.
–
= the rinse aid empty
notification is activated.
2. Press
to change the setting.
3. Press the on/off button to confirm the
setting.
7.4 AirDry
AirDry improves the drying results with less
energy consumption. The appliance door
still flashes.
still flashes.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
