Sun Threshold Regulator (In Connection With A Suitable Sensor From The Controller Manufacturer); Test Mode; Factory Default Settings - Becker Centronic SunWindControl SWC445-II Montage- En Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Sun threshold regulator (in connection with a suitable

sensor from the controller manufacturer)

You set the sun threshold value with this regulator (between about 2 kLux and

100 kLux).

The sun threshold value can be adjusted in 15 steps. When slowly turning the

regulator, the tubular drive clicks to indicate the setting changes.

- Left stop

+ Right stop

Changes made to the threshold value are transferred immediately.

When setting the threshold, ensure that no button is

pressed. If the set sun threshold value is exceeded, the sun

protection system extends after a delay of up to 5 minutes.

The sun protection system automatically retracts after the

sunshine level has been continuously below the threshold

value for about 15 minutes.

The TEST mode is activated by adjusting the threshold value. It automatically

ends after about 15 minutes. In TEST mode, the time for which the wind is

monitored is shortened.

Sun threshold value

Wind threshold value

20 - en

Stage 1, retract at low sunshine level

Stage 15, retract at full sunshine

Medium setting (about 25 kLux)

Left stop (about 2 m/s)

Inhoudsopgave

Advertenties

Hoofdstukken

Inhoudsopgave