Explanation Of Functions - Becker Centronic SunWindControl SWC445-II Montage- En Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Explanation of functions

Manual/Automatic slide switch

In slide switch position " " only manual drive commands and alarm signals can

be performed (e.g.: RETRACT, STOP, EXTEND via button actuation and wind

alarm).

In slide switch position " " automatic drive commands are performed (e.g.

sun protection, ...).

The automatic sun protection functions are interrupted if a manual drive com-

mand is carried out when in automatic mode. These functions are automatic-

ally re-activated if upper/lower threshold limits are violated, following retrac-

tion, or if the slide switch is switched from " " to " " and back to " ".

Channel

The channel of a transmitter can be programmed into one or more receivers.

One receiver is operated through an individual command, several receivers

through a group command.

Central command

If all the channels of the transmitter are selected, it is possible to operate all of

the assigned receivers/groups simultaneously.

Channel selection button

Up to 5 channels can be selected using the channel selection button. The indi-

vidual channels are indicated by the corresponding channel indicator lamp

lighting up. If all of the channel indicator lamps light up simultaneously, the

central command can be programmed or transmitted.

You can make a note of the programmed channel in the la-

belling field underneath the transparent film.

Channel indicator lamps

A radio signal is indicated by the corresponding channel indicator lamp light-

ing up. The respective channel indicator lamp flashes while transmitting if the

battery is getting weak. The transmission strength and the radio range de-

crease as battery power declines. If the channel indicator lamp no longer

lights up when a button is pressed, the battery must be replaced.

18 - en

Inhoudsopgave

Advertenties

Inhoudsopgave