Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Basic settings
Basic settings
9 Basic settings
You can configure the basic settings for your appliance to meet your needs.
9.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Setting
Selection Meaning
Button tone
¡
¡
Demo mode
Factory setting (may vary according to model)
1
9.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold
and
1.
a The display shows the first basic setting.
Press .
2.
a The current value flashes on the display.
Use the settings area to set the required value.
3.
To accept the basic setting, press .
4.
To exit the basic setting, press
5.
Use the settings area to switch to the basic setting
6.
.
To edit the basic setting, press .
7.
a The selected setting lights up on the display.
Use the settings area to set the required value.
8.
To accept the basic setting, press .
9.
10.
To exit the basic setting, press
To exit the basic settings menu, press
11.
Tip: The setting can be changed at any time.
9.3 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
Cleaning and servicing
10 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
10.1 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
32
1
Switch the button tone on and off.
Note: The button tone remains active for
Activate or deactivate demo mode.
Note: The appliance is switched off. You can use the buttons and the display; the but-
tons do not work. Demo mode is mainly useful for dealers.
for a few seconds.
.
.
again.
and
.
Press and hold
for approx. six seconds.
▶
a The signal duration switches between short and
long.
a The appliance applies the signal duration and dis-
plays the time.
9.4 Setting the time
Note: After connecting the appliance to the power or
following a power cut, a signal sounds and several
zeros are shown on the display. It may take a few
seconds until a signal sounds and you can set the
time.
Requirements
¡ An audible signal sounds.
¡ 12:00 is shown on the display.
¡ The indicator light lights up via
Set the time via the settings area.
1.
Press
.
2.
9.5 Hiding the clock
To reduce the standby consumption of your appliance,
you can hide the clock.
Press
.
1.
Press
.
2.
To view the clock, press
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
.
again.
Advertenties
Hoofdstukken
Inhoudsopgave
