Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
Place the appliance on a firm and flat surface (floor) so that it is
stable, otherwise vibrations and noise may occur. When placing
the appliance on floor coverings such as carpets, straw mats or
polyvinyl chloride (PVC), place a solid sheet or cover under the
appliance to prevent colour change due to heat dissipation.
4. Clean
Before putting the appliance into use, clean the interior and all
associated accessories with lukewarm water and neutral soap. Dry
everything carefully. Do not use solvents or abrasive powders; these
may damage the coating.
5. Wait
On first installation (or after turning the door) wait at least four hours
before plugging in the appliance. This allows the oil to flow back into
the compressor.
6. Switch on
Before plugging in the power cable, check that the voltage and
frequency of the type plate match your power supply network. Only
connect the appliance to an earthed power socket. After one hour,
open the door of the appliance. If the temperature in the appliance
is noticeably lower, this indicates that the cooling system is operating
normally.
7. Mounting accessories
- Adjustable shelves
The walls of the appliance are equipped with a series of guide
profiles so that the shelves can be inserted if desired.
- Fitting of accessories
To place the glass shelves in the appliance, tilt the shelf about 60
degrees and slide it into the guide (see drawing).
- Installing the door compartments
To store food of different sizes, the door compartments can be set to
different heights. Proceed as follows: gradually pull the compartment in
the direction of the arrows until it comes loose and put it in the desired
position.
8. Storing food
•
See Section 4 "Use".
35
Advertenties
Hoofdstukken
Inhoudsopgave
