Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Chapter 2 Use for the Generator Set
2.1 Use Essentials and Cautions
In order to ensure that you safely operate the generator set, be sure that you read and
understand the operation manual. Especially the attention should be paid to the use main
points listed below. Otherwise the personal accidents and the equipment damages may be
caused.
2.1.1 Fire prevention.
The combustion oil used in the diesel engine is light diesel oil. The gasoline, kerosene
and other oils should not be used.
Use a clean cloth to wipe off the overflowed oil. The gasoline, kerosene, match and other
inflammable and explosive matters should not be put near the set because the temperature
for the place around the exhaust noise suppressor is very high while the diesel engine is
running.
For the purpose to prevent the fire and to supply the sufficient ventilation condition,
during the operation, at least 1.5m distance between the set and the building and other
equipment should be kept.
Operating the welder and generator set should be carried out on a smooth floor. If the set
is oblique, the oil will overflow.
2.1.2 Prevent the suction of the exhausted gas includes the poison carbon monoxide.
At the places with poor ventilation, the welder and generator set should not be used. If it
is necessary to operate the set indoors, the suitable
ventilation condition should be supplied to prevent
the personnel and livestock from the affection.
2.1.3 Prevent the burn.
When the diesel engine is running and is hot, it is
not allowed to touch the noise suppressor and its
housing.
2.1.4 Electric shock and short-circuit.
In order to avoid the electric shock or the
short-circuit, when the welder and generator set is
wet or when your hand is wet, contacting the
welder and generator set is not allowed. This
welder and generator set is not waterproof so that it should not be used at the places in
rain, snow and water mist.
In order to prevent the electric shock, the welder and generator set should be
grounded. Connect the grounding terminal of the generator with the external grounding
device by using a conductor. Don't connect the other equipment with the welder and
generator set.
2.1.5 Other safety main points.
In order to know how to quickly brake the set, the operators should be familiar with
operating all the switches. Anyone without passing through the correct guidance should
not carry out the operation. The operators should wear the safety shoes and the suitable
21
Advertenties
Hoofdstukken
Inhoudsopgave
