Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26 Progress
Problem
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Replacing the lamp
The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION! Disconnect the plug
from the mains socket.
1. Using a screwdriver, remove the screw
from the lamp cover.
2. Detach the lamp cover in the direction
of the arrows.
Possible cause
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
3. Replace the lamp with the one that has
identical characteristics and is
specifically designed for household
appliances.
4. Reassemble the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light switches on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
Solution
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Defrost the appliance.
Open the door only if necessa‐
ry.
Make sure that there is cold
air circulation in the appliance.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
