Advertenties
Beschikbare talen
Beschikbare talen
Warranty conditions
The pump is covered by a 36-month warranty from the date of purchase. Please
keep the receipt for future reference.
Within the period specified, repair or replacement of damage caused as a result of
manufacturing and/or material defect will be free of charge. Rotor, normal wear
and tear, dry running, operating errors, scale, lack of maintenance, freezing,
improper repairs and damage caused by improper use are not covered by the
warranty.
Any modification or alteration of the pump, such as shortening the power cord or
cutting the plug off, will render the warranty null and void.
The supplier is not liable for consequential damage arising from pump failure or
misuse.
For warranty claims, take the product, the product warranty and receipt to the
retailer.
Security and error messages
The built-in protection switches the pump off in case of faults and will indicate a
fault code on the display of the controller.
Error code:
Cause:
Single digit
Pump does not work
E01
Low water security
Overload protection
E02
(Amperage)
Phase failure, bad or
E03
defective cable connection
E05
Rotor lock protection
E06
Overvoltage protection
E07
Low voltage protection
If the cause of the fault is unclear - or cannot be remedied -, please contact your pump
supplier. Do not use the pump again!
The house voltage and voltage at socket of the pump must be checked by a recognized
electrical installer.
English
Solution:
Remove mains plug from socket, wait until display on controller
is off.
Plug the plug back into the socket and start the pump.
There is not enough water supply to the pump, determine the
cause and solve it. Remove the plug from the socket. Check the
water level - contamination of the suction strainer or pipes.
When the problem has been solved, plug in the mains plug and
start the pump.
Remove plug from socket, wait until display on controller is off.
Plug the mains plug back into the socket and start the pump.
Check the plug coupling, power cable and plug for possible
damage, do not repair any damage yourself, contact your
supplier.
Check if the rotor / pump impeller is blocked by dirt particles.
Remove the plug from the socket and wait until the display on
the controller is off. Clean the rotor / pump impeller. See
disassembly and assembly.
Put the plug in the socket and start the pump.
The mains voltage present at the socket must be in accordance
with the required pump voltage (see pump label).
Consult the installer.
The mains voltage present at the socket must correspond to the
required pump voltage (see pump nameplate).
Consult installer.
www.auga.nl
34
Advertenties
