Advertenties
Beschikbare talen
Beschikbare talen
Do not use the pump when there are people in the water! (Isolate the
•
pump from the mains network).
Observe the safety instructions.
•
Uses: Swimming lake or swimming pool (if people use the water!) (see
image 3)
Caution:
This pump may only be used out of the water; it must be installed a minimum of
2 metres from the pool, according to the instructions!
The pump is suitable for use in installations and spaces in line with DIN
•
VDE 0100 parts 702 and 737, if the set-up guidelines DIN VDE 0100 and
the manufacturer's instructions (for assembly and operations) have been
followed.
If you are to install these pumps in swimming lakes/pools, you must
•
adhere to the following norms: DIN EN 13451 part 1 to part 8 and DIN
VDE 0100 part 702 and part 737.
The following instructions must be followed: (see figure 3)
Create a shaft and a platform for the pump, a min. of 2 cm from the
•
water's edge.
Protect the shaft with a cover.
•
In order to protect the pump from flooding, you must create a run-
•
off in the shaft so that excess water can drain into the garden,
sewers, etc. If this is not possible, a submersible pump with a float
must be used in order to provide a flooding safeguard.
Secure the pump to the platform with screws.
•
In the suction pipes to the pump, install a metal "M" coupling sleeve
•
to the connection in the equipotential connector from the
lake/swimming pool installation!
In the event of any doubts, please consult an electrician.
•
See also "dry installation".
•
Observe the safety instructions.
Safety instructions
Warning! This pump may only be used if the electrical system meets
•
relevant statutory requirements.
If in doubt, consult a qualified installer.
The pump may only be connected to a system with a ground-fault
•
circuit interrupter (30mA) and earthed power outlet.
The mains voltage and current type must match the information on the
•
nameplate or table on page 2.
Place the power outlet in a moisture-free area, at least 2m from the
•
water's edge (see image 1.)
Check the power cord, plug and VarioFlow-E Control panel for damage
•
before using the pump.
Important: if damaged, do not use the mains cable, engine housing or
•
operating panel.
English
www.auga.nl
30
Advertenties
