Advertenties
Beschikbare talen
Beschikbare talen
PROXIMA USB
&T0
&T1
&T3
&T6
&V
&W
&Zn=x
* Manufacturer default
Extended "AT\" (Back Slash) Command Set
Command
Options
\Jn
\J0 *
\J1
\Nn
\N0
\N1
\N2
\N3 *
\N4
\Qn
\Q0
\Q1
\Q3 *
\Tn
n=0 *
n=1 -
255
\Vn
\V0
\V1 *
* Manufacturer default
Extended "AT%" (Percent) Command Set
Command
Options
%B
%Cn
%C0
%C1 *
* Manufacturer default
Extended "AT-" (Dash) Command Set
Command
Options
-Cn
-C0 *
-C1
* Manufacturer default
.
Terminate any test in progress
Local analog loopback test
Local digital loopback (LDL) test
Remote digital loopback test, in normal mode
View active file and stored phone numbers
Store active configuration into the modem's NVRAM
Store telephone number
n=0 to 3
x=<string> see also the dial modifier
in "ATDn" command
The max. number of digits per string is 40.
Function & Description
Constant DTE speed option
DCE and DTE rates are independent
Force the DTE interface speed to the DCE connection rate (line speed) after on-line
Error control mode options
Buffered mode, no error control (flow control is allowed).
Direct mode, no error control (no flow control is allowed).
MNP reliable mode. If MNP 2-4 error control establishment fails, the modem
disconnects.
V.42, MNP or buffer mode. The modem attempts to connect in V.42 mode. If this
fails, the modem attempts to connect in MNP mode. If this fails, the modem
connects in buffer mode.
V.42 or disconnect. The modem attempts to connect in V.42 mode. If this fails, the
call will be disconnected.
Local flow control options
Disable flow control (same as "AT&K0")
XON/XOFF software flow control (same as "AT&K4")
RTS/CTS hardware flow control (same as "AT&K3")
Set inactive timer (for buffer mode only)
Disable inactive timer
Enable inactive timer. Length in minutes
Protocol result codes
Disable protocol result code appended to DCE speed
Enable protocol result code appended to DCE speed
Function & Description
View numbers in blacklist. If blacklisting is in effect, this command displays the
numbers for which the last call attempted in the past two hours failed. The ERROR
result code appears in the countries that do not require blacklisting.
Data compression control
No data compression
V.42bis/MNP 5 data compression enabled.
Function & Description
Data calling tone options
Disable data calling tone
Enable data calling tone (the freq. is 1,300 Hz with a cadance of 0.5 sec. ON and 2
sec. OFF)
61
BAUSCH DATACOM
Advertenties
Hoofdstukken
