Programming The Radio; Programming Additional Transmitters - Becker Centronic SunWindControl SWC545 Montage- En Gebruiksaanwijzing

Zon-windbesturing met display

Inhoudsopgave

Advertenties

Beschikbare talen

1) Programming the master transmitter

a) Put receiver into programming mode

Note

Please refer to the operating instructions for the receiver.

• Switch off the receiver's power supply and reconnect after 5 seconds.

• Activate the "Programming" key or the radio-controlled receiver switch.

The receiver will then be in "Programming" mode for 3 minutes.

b) Programming master transmitter

When the receiver is in "Programming" mode, the programming button is to be

pressed until the receiver indicates that the programming process has been

successfully completed.

The programming process is now complete.

a) Press the programming button of the master transmitter until acknowledge-

ment is given by the receiver.

b) Now press the programming button of the new transmitter until acknowl-

edgement is given by the receiver.

c) Then press the programming button of the new transmitter to be learnt once

again.

The receiver will indicate when the programming process has been successfully

completed.

The maximum radio range is up to 25 m indoors and up to 350 m in the open.