Sensors; Explanations - Becker Centronic SunWindControl SWC545 Montage- En Gebruiksaanwijzing

Zon-windbesturing met display

Inhoudsopgave

Advertenties

Beschikbare talen

The radio controlled sun-wind sensor (Centronic SensorControl SC811 or

SC861) can be programmed at the device. (See the operating instructions of

the respective sensory equipment).

Manual/Automatic sliding switch

In the "" mode, only manual control commands and alarm signals are executed

(e.g.: by pressing RETRACTION, STOP, EXTENSION buttons and wind alarm).

When the sliding switch is set to "" mode, automatic control commands are

carried out (e.g. Automatic sun protection function, ...).

Transmission control light

A radio signal is indicated by the transmission control light being lit. If the battery

is running low, the transmission control light flashes during transmission. The

transmitter power and/or radio range is reduced when the battery is running low.

If the transmission control light is no longer lit when the pushbutton is pressed,

the batteries must be changed.

Group

Group control means controlling one or several receivers at the same time. The

programmed group is activated using a single command.

When the SWC545 is used, the groups are controlled using six radio channels.

Group pushbutton

The group pushbutton may be used to select up to 5 channels. Operation of the

individual channels is indicated by the relevant LED lighting up.

An additional channel is reserved for the central command. This is allocated

automatically. Operation of the central command is indicated by all five LEDs

lighting up.

Note

You can note the programmed groups on the label under the see-

through cover.

Sensors

Inhoudsopgave

Advertenties

Inhoudsopgave