Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
VDV-2010
ENGLISH
VDV-2020
Changing the radio chime ring tone
To change the ring tone, proceed as follows:
30. Press and hold the bell button* and the
button (17) simultaneously until the out-
door unit emits tones. Then release both
buttons.
*With the VDV-2020, the ring tone for both
buttons can be set separately by pressing the
corresponding ring button together with
button (17) here.
31. When the name plate flashes green, you
can press it and the receiver will play the
GB
next ring tone. Wait until this has been
completely played by the receiver before
you select the next tone by pressing the
name plate. A total of 8 ring tones are
available
32. To save the ring tone, press the button
(17). The outdoor unit confirms the suc-
cessful storage with a long tone.
Changing the coding
If your radio chime receiver activates without
someone having rung the bell, an overlap
with another radio in the neighbourhood
could be the cause. In this case, you can
change the transmitted code of the outdoor
station as follows:
33. Press and hold the bell button* and the
button (17) simultaneously. After approx.
3 seconds the outdoor unit emits 3 tones,
continue to hold the buttons down. After
another 3 seconds, the outdoor unit
emits several tones. Now you can release
the buttons, the code has been changed.
*With the VDV-2020, the code for both but-
tons can be set separately by pressing the
corresponding bell button here.
34. Reset the radio chime receiver to factory
settings to delete all learned transmit-
ters. The receiver must then be taught in
again. Refer to the operating instructions
for your receiver.
36
Advertenties
Hoofdstukken
Inhoudsopgave
