Programming The Remote Control; Learning Additional Transmitters - Becker Centronic EasyControl EC541-II Montage- En Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor Centronic EasyControl EC541-II:
- Montage- en gebruiksaanwijzing (44 pagina's) ,
- Montage- en gebruiksaanwijzing (34 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Programming the remote control
1) Learning the master transmitter
a) Put receiver into learn mode
Note
Always follow the installation and operating instructions of the receiver.
Use a suitable cylindrical tool (e. g. ball-point pen) to actuate the pro-
gramming button on the transmitter.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Actuate the programming button or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
Press the programming button of the master transmitter in programming mode
until the receiver acknowledges successful programming.
The learn process is now complete.
2) Learning additional transmitters
a) Press the learn button of the master transmitter until acknowledgement is
given by the receiver.
b) Now press the learn button of the new transmitter until acknowledgement is
given by the receiver
c) Then press the learn button of the new transmitter to be learnt once again.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 25 m outside and inside the building and up
to 350 m in the open.
de
en
fr
nl
13
Advertenties
Inhoudsopgave
