Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
14. BUILT-IN CONTROL – CONNECTION DIAGRAM SLIM W; SLIM N;
∼
❶ Power supply: 1N
230V/50Hz (min.3x1,5mm
❷ SRQ3d ½"; SRQ2d ½"
valve with actuator
-
The maximum outer diameter of the cable sleeve is 14.0 mm;
-
The minimum outer diameter of cable sleeve is 4.0 mm;
Maximum wire diameter 4,0 mm
❸ Motion sensor; to omit/bypass the motion sensor; disconnect and insulate / secure wires from connectors D; D, a cable jumper
(min. 1x1,0 mm
2
) or a door sensor (min. 2x1,0 mm
❹ Heating switch (SLIM W) ( I – valve open , O – valve closed); Valve – an optional accessory;
❺ Fan step switch (SLIM W/N) ( I – 1st fan step, O – device OFF, I I – 3rd fan step).
1) To connect the 2nd fan step, connect the cable from the 6th connector to the 7th connector.
In this case, the I position on the switch will mean SWITCHING ON the 2nd fan step.
2) Each time the curtain is turned on by a motion sensor, it operates for a set time (10 s by
default), unless motion is detected in the area covered by the sensor.
ADVICE
3) The device starts automatically when motion is detected in the sensor area and works
according to settings selected on the switches.
VALVE PARAMETERS SRQ:
- SRQ3d ½" – Three-way valve ½" with actuator
- SRQ2d ½" – Two-way valve ½" with actuator
14
PIC. 14.1 POWER SUPPLY 1N ∼ 230V/50 Hz
; Protection B4)
2
(min.3x0,75mm
)
2
.
2
2
) should be connected in this place;
Class of protection: IP20
Supply voltage: 230/50 Hz
Max. Medium temperature: + 93oC Max. Operating pressure: 2.1Mpa
SRQ2d 1⁄2 "Kvs: 3.0 m
SRQ3d 1⁄2 "Kvs: 3.4 m
Motor running time: 18 s
A – Return pipe water supply
AB – Valve water supply
B – Exchanger water supply
/h
3
3
/h
Advertenties
Inhoudsopgave
