Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
11. CONNECTION OF ELECTRICAL INSTALALTION
PIC. 11.1 REMOVE THE SCREW NEXT TO THE GRILLE.
PIC. 11.3 OPEN THE SERVICE HATCH.
PIC. 11.5 CONNECT THE CABLE.
1. The power connection should be made in accordance with the technical documentation. The device
installation should always be carried out in accordance with applicable local safety standards.
2. The cross-section and type of cable should be selected by the designer. (Always make sure that the
disconnectors and protective switches are properly sized).
3. Make sure that the connection of power supply and controllers to the Slim curtain is made in accordance with
the electrical specifications and the instructions included in the connection diagrams in the technical
documentation.
4. Before connecting the power supply, check that the mains voltage corresponds to the voltage on the device's
type plate.
5. Check the power connection before connecting the air curtain.
WARNING
6. Starting the device without connecting the grounding wire is not allowed.
7. Protect the power cord against pulling out by clamping the PG16 or PG11 cable gland
8. Tighten all connection cables in the block properly
9. In the event of a hazard due to unintentional reset of the thermal switch, this curtain (SLIM E) should not be
powered by an external connecting device such as a time switch, or connected to a circuit that is regularly
switched off and switched on during use.
10. Do not start the device with the service hatch open.
x1 PH2
PIC. 11.2 REMOVE THE SCREWS FROM THE FRONT.
PIC. 11.4 PUT THE CABLE THROUGH THE GLAND.
ADVICE
The power cord can be attached to the
enclosure using the fasteners.
PIC. 11.6 FASTEN THE CABLE TO THE DEVICE CASING.
SLIM .. 100 x3 PH2
SLIM .. 150 x4 PH2
SLIM .. 200 x5 PH2
11
Advertenties
Inhoudsopgave
