Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Prior to initial use
Overflow protection
Switching on
Delayed start (only for EVW8162/EVW7963)
Attention:
• Always fill the salt reservoir and adjust the water hardness setting
before using the dishwasher (see page 15).
• Also fill the rinse agent reservoir and the detergent reservoir (see
page 16, 17 and 18).
Your dishwasher is equipped with a safety device which prevents the
dishwasher from being overfilled with water. The safety device closes
the intake valve and assures that the dishwasher pumps out the excess
of water. When there is water inside the diswasher (because too
much water is pumped in or in case of a leakage), the water has to be
removed before you switch on the dishwasher again.
1. Open the door of the dishwasher.
2. Check if the plug of the connecting cord is in the socket.
3. Check if the water supply is turned on.
4. Load the dishwasher (see page 18: "loading the baskets").
5. Pour in the detergent.
6. Press the On/Off button to switch on the appliance. The indicator will
light up when the machine is switched on.
7. Select the desired cycle (see page 14).
▷ EVW7947/EVW7961: press repeatedly the washing program
selector button to select the desired washing program. The
indicator of the selected program will light up.
▷ EVW8162/EVW7963: turn the washing program selector to select
the desired wash cycle.
8. Close the door.
9. Press the start button to start the washing.
If you want the dishwasher to switch on at a later time, you can used the
'delayed start' button. You can choose to delay the start time by 2, 4, 6 or
8 hours. Each press of the button changes the delay time with two hours.
EN 11
Advertenties
Hoofdstukken
Inhoudsopgave
