Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FAULTS
Symptom
Contamination of the tub.
Dishes not dry.
Dishes and flat objects are
not clean.
Spotting and scaling on
glasses and flat dishes.
Cloudy stains on the
glassware.
Yellow or brown scale on the
inside of the tub.
White scale on the inside of
the tub.
Possible cause
Poor quality detergent.
Blocked filters.
Rinse agent has been spilled.
The rinse agent reservoir is
empty.
Incorrect cycle.
Baskets are incorrectly
loaded.
Extremely hard water.
Incoming water temperature
is low.
The dishwasher is
overloaded.
Baskets are incorrectly
loaded.
Old or damp detergent.
Rinse agent reservoir is
empty.
Incorrect detergent dosage.
Combination of soft water
and too much detergent.
Traces of iron in the water
may cause spotting to the tub
of the dishwasher.
Hard water.
Solution
Only use detergent suitable
for dishwashers to prevent
contamination.
Open the door and clean
the filters. Run the pre-wash
cycle.
Always wipe up spilled rinse
agent immediately.
Ensure that the rinse agent
reservoir is filled.
Select a higher cycle.
Make sure that the detergent
compartment and spray arms
are not obstructed by large
dishes/pans.
To remove spotting from
glass objects: remove
all metal objects from
the dishwasher. Use the
prescribed quantity of
detergent. Select the longest
cycle. Allow the dishwasher
to run for approximately
18 to 22 minutes. It should by
then have reached the main
wash cycle. Open the door
carefully and pour 2 cups of
white vinegar into the base.
Close the door and allow the
dishwasher to complete its
cycle.
If vinegar does not work:
repeat the above steps, but
use a quarter cup (60 ml) of
citric acid crystals in place of
white vinegar.
Use less detergent and
choose the glass cycle,
which you can use to clean
glassware.
Contact a manufacturer of
water softeners for a special
filter.
Increase salt consumption
setting.
EN 27
Advertenties
Hoofdstukken
Inhoudsopgave
