Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7.2.2 Battery charge state indicator
The battery charge state indicator is located at the top
right of the display. Using a battery symbol divided into
seven segments, it shows the charge remaining in the
battery. The lower the charge state of the battery, the
fewer segments are displayed.
DISPLAY
BATTERY CHARGE STATE
100-85.5%
85.5-71.5%
71.5-57.5%
57.5-42.4%
42.5-28.5%
28.5-14.5%
If the battery charge state falls below a minimum level,
the motor assistance switches off. Then the entire display
fades and goes off, too.
If you do not use your Pedelec for ten minutes, the
system switches off automatically. If you then want
to ride using the assistance, you will have to switch it
back on via the control unit.
7.2.3 Remaining range indicator
Below and to the right of the battery charge state indica-
tor, the distance in km over which you can still travel with
power assist is displayed. This is the remaining range
indicator.
If the riding conditions change, for example, when
you come to a hill after a long, flat stretch, the value
displayed can also change at short notice. Please
consider this factor when planning your trips. You are
probably familiar with this effect from the remaining
range indicator of your car. The remaining range de-
22
Original User Manual | Pedelec Impulse 2.0 Ergo
pends on the current battery charge state and the as-
sist mode which has been set (ERGO, POWER, SPORT
or ECO).
7.2.4 Units
Press and hold the
button for three seconds to switch
between kmh (speed)/ km (remaining range indicator) and
mph/mi.
7.3
Programming and settings
After switching on the Impulse system, you can switch
from the main menu to the menu sub-items, by pressing
the
button for three seconds.
This takes you to the menu sub-items:
• Drive data ➠ Chapter 1.2.1
• Delete trip data ➠ Chapter 7.3.2
• Delete overall data ➠ Chapter 7.3.3
• Device settings ➠ Chapter 7.3.4
• Personalize ➠ Chapter 7.3.5
• Target cost ➠ Chapter 7.3.6
• ERGO settings ➠ Chapter 7.3.7
• Back
You can select the menu sub-items using the
on the control unit. Confirm your selection by pressing the
button. The respective contents are then displayed for
you. To return to the main menu display from the menu
sub-items, you must select "Back" and confirm by press-
ing the
button. You can also return to the main menu by
pressing and holding the
7.3.1 Drive data
The following data are displayed in the menu sub-item
"Drive data":
• Trip (in km)
• Trip time (in 00:00:00)
• Trip max (in km/h)
• Trip Ø (in km/h) = Trip average
• Trip cost (in €)
• Tour (in km)
• Tour Ø (in km/h) = Tour average
• Tour cost (in €)
• Overall (in km)
• Overall savings (in €)
• Tot. sav. CO2 (in kg)
• Back
/
buttons
button for three seconds.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
