Advertenties
Beschikbare talen
Beschikbare talen
EN
soleplate. During operation, the power cord must always be fully extended and the position
of the power cord must be set so that it does not become an obstacle during product oper-
ation. The power cord should not be placed in a manner that would pose a risk of tripping.
The power supply socket should be located in a place where it is always possible to quickly
remove the product power cord plug. Always pull the power cord by the plug housing when
unplugging it, never by the cord.
If the power cord or the plug is damaged, immediately disconnect it from the power supply
and contact an authorised service centre of the manufacturer for replacement. Do not use the
product with a damaged power cord or plug. The power cord or plug cannot be repaired and
must be replaced with a new one that is free of defects if these components are damaged.
Instructions for use
Disconnect the power cord plug from the power supply socket before fi lling in the iron tank
with water or emptying it.
When the iron is in use, the soleplate is heated up to the high temperature and steam is
generated. Contact with soleplate or steam can lead to serious burns.
The water tank cover must always be properly closed when ironing.
The iron must be used and placed on a fl at and stable surface. If the iron is placed on its own
base, make sure that the base is placed fi rmly.
Do not use the iron if it has been dropped, if there are visible signs of damage or if it is leaking.
Return a defective iron to an authorised service centre for repair before reusing it.
When using the iron, always hold the iron by the handle. Never touch the iron's soleplate.
Do not iron clothes that are on the body of the user or others. Using the iron in this way will cause
serious burns. The steam outlet must never be pointed in the direction of people or animals.
Pour only clean tap water, demineralised water or distilled water into the iron tank. Do not add
any substances, e.g. perfume to the water. Such use is not in accordance with the intended
use and will result in damage to the iron. Do not pour any liquids other than water into the
tank. Pour in and pour out water only if the iron's soleplate is completely cooled down. When
pouring in water, be careful and minimise water spills. Do not place the iron directly under the
tap to fi ll the tank in. Never immerse the iron in water or any other liquid. Use the fi lling cup
provided to pour water into the iron's tank. Do not use water from desilters of air conditioners,
dryers or similar equipment.
Never place the iron on its soleplate when it is connected to the power supply. During short
breaks in ironing, the iron should be placed in a vertical position, resting it on the back wall or
on a base if provided and the instructions for use permit such use of the base.
APPLIANCE OPERATION
Preparation for the fi rst use
Remove the appliance from its packaging by removing all packaging components.
If the iron's soleplate has been secured with a protective fi lm, remove it completely. Do not use sharp tools that could damage
the surface of the soleplate.
Press and hold the handle lock button (II), then lift the handle until it locks into the upper position.
Check the setting of the voltage switch (III). The switch should be set according to the voltage of the power network applicable in
the country where the iron is used.
The sound of the ratchet mechanism should be audible. The correctly raised handle cannot be lowered except by pressing and
O R I G I N A L
I N S T R U C T I O N S
11
Advertenties
