Advertenties
Do not store batteries on the charger. Always remove the battery from the charger when the
▶
charging operation has completed.
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized
▶
persons.
Prior to each use and before and after prolonged storage, check the product and the batteries for
▶
damage.
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed
Status indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem
by yourself, contact Hilti Service.
Trouble or fault
LEDs of the battery show
nothing
The on/off button cannot be
pressed, i.e. the button is
locked.
Running speed suddenly
drops considerably.
Chips are not transported
away; they drop on to the
base plate
The product doesn't restart
by itself after the saw blade
has stalled.
The battery does not en-
gage with an audible click.
Product vibrates more than
usual.
The pivoting guard does not
close.
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short
▶
circuiting.
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or
▶
public health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, your old tools, machines
or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative
for further information.
34
Possible cause
Battery defective
Not a fault (safety function).
Battery is discharged.
Saw advance pressure is too
high.
The chip / dust channel is
blocked.
The overload cut-out has been
activated.
The retaining lugs on the battery
are dirty.
The saw blade is fitted incorrect-
ly.
Pivoting guard dirty or jammed,
or the spring is damaged
Action to be taken
Contact Hilti Service.
▶
Press the switch-on interlock.
▶
Charge the battery.
▶
Reduce advance pressure and
▶
switch the power tool back
on.
Clean the chip ejector channel.
▶
33
Press the switch-on interlock
▶
and the on/off button again.
Clean the retaining lug and
▶
re-insert the battery.
Remove the saw blade and
▶
refit it correctly.
Contact Hilti Service.
▶
2360043
*2360043*
Advertenties
