Advertenties
3.Tighten the cutting depth adjustment clamping lever (3).
The cutting depth should always be set to a depth approx. 5 to 10 mm greater than the
thickness of the material to be cut.
Setting cutting angle for bevel cuts
You can set the bevel to a cutting angle between 0° and 53°. The bevel angle preselector
enables you to preset the maximum selectable angle to 22.5° or 45°.
1.If applicable, set a maximum angle by means of the bevel angle preselector.
2.Release the bevel angle preselector clamping lever (1).
3.Swivel the product to the desired bevel cutting angle (2).
4.Lock the product at the set bevel cutting angle with the clamping lever (3).
Installing parallel guide
1.Release the clamping lever (1).
2.Push the parallel guide into the base plate.
You can adjust the cutting width to suit your application (2).
▶
3.Close the clamping lever.
Installing guide rail adapter (accessory)
1.Remove the parallel guide, if fitted.
2.Hook the base plate into the rear retaining lugs of the guide rail adapter (1).
3.Set the base plate down on the guide rail adapter (2).
The base plate is flush on the guide rail adapter.
▶
4.Lock the guide rail adapter by pressing in the two sliders (3) as far as they will go.
Operation
Observe the safety instructions and warnings in this documentation and on the product.
Switching on or off
Switching on
1.Press and hold down the switch-on interlock and press the on/off button.
You can release the switch-on interlock as soon as you have the on/off switch held down.
▶
Switching off
2.Release the on/off switch.
The switch-on interlock jumps automatically into the locked position.
▶
Dust and chips management
• Sawing with dust extractor:
Connect the suction hose to the dust removal connector and follow the instructions in the operating
instructions for the dust extractor.
• Sawing with dust bag:
Connect the dust bag with the adapter to the dust removal connector for dust extractor.
You can also operate the product without dust collection method. Make sure that sawdust and
chips can be ejected without obstruction.
Sawing along a line
Saw only flat workpieces that offer a big enough contact surface to accommodate the whole of
the base plate.
1.Position the workpiece so that the saw blade is free to rotate beneath it.
2.Secure the workpiece to prevent movement.
*2360043*
7
5
8
2360043
6
31
Advertenties
