Advertenties
Bow thruster
The configuration as supplied is for application as a bow thruster.
Stern thruster
Configure a stern thruster by cutting through the red wire as indica-
ted in the drawing.
• Reinstall the cover and tighten the glands.
Main power fuse 2
In the connection unit, there
is a main power fuse on the
controller.
This fuse protects the con-
troller and motor against
short
circuit/overloading
and it must remain present
under all circumstances.
When replacing the fuse, the replacement must be of the
same rating.
5.6
Connecting CAN bus (control current) cables
See diagrams from page
97
if multiple panels have to be connected.
The CAN bus power supply must always be connected to
12 Volt (≥10 V, ≤16 V). Use the E-Drive MPE1KB key switch as
power supply.
As required by international standards, all neutral (negative)
conductors of the DC system must be connected to one central
point. This prevents not only dangerous situations and corrosion
problems, but also error messages in the CAN bus system.
22
020806.08
Red
n
ote
n
ote
c
aution
6
Technical data
Type
:
Electromotor
Type
:
For DC systems
:
Current (In)
:
Power consumption :
Rating
:
Protection
:
Insulation class
:
Motor controller
MCV
:
Transmission
Gears
:
Gear ratio
:
Lubrication
: oilbath, outboard gear oil SAE80W or EP 90
:
Propeller
No. of blades
:
Profile
:
Material
:
Rated thrust
:
Control circuit
Fuse
:
Control circuit wires : 2 x 2x 0,5 mm
Extension cable
: 5, 10, 15, 20 or 25 m (16' , 33' , 49' , 66, or 82')
Thrust-tunnel
Steel model
dimensions
: O.D. outside 194 mm, wall thickness 5,6mm
blasted, coated with: SikaCor Steel Protect.
treatment
:
Suitable for all kinds of protection systems.
Plastic model
dimensions
:
material
:
Aluminium model
dimensions
: I.D. inside 185 mm, wall thickness 5,5 mm
material
:
Weight
Excl. thrust-tunnel
:
[1]
S2 't' min. Activation time 't' min. continuously or a max. of 't'
min. per hour at maximum power.
vetus® Installation manual BOW PRO Series Thrusters: BOWA0651 and BOWA0764
BOWA0651
BOWA0764
EC Motor
EC Motor
(8VAC-2.7kW)
(15VAC-3.1kW)
12 V =
48 V =
237 A @ 12,0 V
82 A @ 48,0 V
271 A @ 10,5 V
93 A @ 42,0 V
2,9 kW
3,9 kW
S2 - 10 min.
[1]
IP44
F
MCV30024
MCV25048C
+ MCV0651S
+ MCV0764S
Bevel gear helical teeth
1,7 : 1
ca. 0.06 litre (2.1 fl.oz.)
6
asymmetrical
polyacetal (Delrin ®)
650 N (65 kgf )
900 N (90 kgf )
Blade type fuse 'ATO' 5 A
2
(2 x 2 x AWG20) Twisted pair
I.D. inside 185 mm, wall thickness 5 mm
glass fibre reinforced polyester
aluminium, 6060 or 6062 (AlMg1SiCu)
35 kg (77 lbs)
Advertenties
