Inhoudsopgave
Advertenties
Pairing (programming) function buttons A1/A2 with the first receiver
1. Turn ON your transmitter.
2. The receiver must be turned OFF.
3. Move the red target of the transmitter towards the receiver so it comes into the
contact with the red target of the receiver and hold for 5 seconds. The red LED
indicator of the receiver will lit up, afterwards the green LED indicator will lit up.
4. After 5 seconds the receiver LED indicators will flash 3 times green and red colour
simultaneously. Afterwards the green and red LED indicators will start alternately
flashing.
5. Press down A1 or A2 button.
6. Successful pairing is indicated by a long beep tone of the receiver.
Pairing (programming) function buttons B1/B2 with the second receiver
Proceed in the same way as in the previous chapter, only in the point 5 press down
the function button B1 or B2.
When you want to use the transmitter for training only one dog, it is possible to
program all four function buttons A1/A2/B1/B2 with the one receiver. You can also
use this function for the professional training and for programming communication
of one receiver with two different transmitters.
Pairing (programming) function buttons B1/B2 (or second transmitter) with the
first receiver
1. Turn ON your transmitter.
2. The receiver must be turned ON.
3. Move the red target of the transmitter towards the receiver so it comes into the
contact with the red target of the receiver and hold for 5 seconds. The green LED
indicator of the receiver will lit up, afterwards the red LED indicator will lit up.
4. After 5 seconds the receiver LED indicators will flash 3 times green and red colour
simultaneously. Afterwards the green and red LED indicators will start alternately
flashing.
5. Press down B1 or B2 button (or any other function button on the second
transmitter).
6. Successful pairing is indicated by a long beep tone of the receiver.
Warning: If you program the receiver from the switched OFF status (see
the chapter 7.4 Pairing (programming) function buttons A1/A2 with the first
receiver), the device that was programmed from the switched ON status will be
automatically removed (mostly used to remove the trainer's transmitter from
your receiver after the training is finished).
7.5 Choice of the contact points
The stimulation is transferred on your dog's skin through the steel contact points
of the receiver. Each set contains 2 types of contact points. Sufficient length of the
contact points has to have a contact with the dog's skin, enabling the device to
operate correctly. If you have a short-haired dog use the 7 mm contact points, if you
have a dog with longer-haired replace them with the longer 10 mm contact points
supplied in the kit. Screw the contact points onto the screws of the receiver - see
30
Advertenties
Hoofdstukken
Inhoudsopgave
