Inhoudsopgave
Advertenties
6
6.1 Battery insertion and replacement
1. Screw out 4 screws from the battery cover using a cross-head screwdriver and
remove the lid.
2. Insert two alkaline AAA batteries into the battery compartment with a correct
polarity (according to the polarity indicated with the "+" symbol in the battery
compartment). Wrong polarity may damage the unit.
3. Make sure that the rubber seal is clean and correctly seated in its groove.
4. Put the battery cover back and screw in the 4 screws adequately.
6.2 Checking the transmitter battery status
The battery power indicator on LCD shows the battery status:
– Fully charged battery
– Medium charged battery
– Flat battery
If the battery is flat, insert new AAA alkaline batteries into the battery compartment.
6.3 Transmitter settings
1. Switching ON/OFF – press down for 1 second the button
2. Selection of function button for setting – by pushing this button
and repeteadly you switch between buttons A1/A2/B1/B2.
Buttons A1/A2 are designed for a dog A and buttons B1/B2 are designed for a dog B.
TIP: When using the device for training one dog, you can program function
buttons B1/B2 with the same receiver (collar) as function buttons A1/A2 -
see chapter 7.4 Pairing (programming) function buttons B1/B2 (or second
transmitter) with the first receiver.
3. Command setting – by pressing down
for the selected function button A1/A2/B1/B2. Selected command will be sent to
the receiver collar. You can select following commands:
continous stimulation and short nick stimulation, vibration, light, beep and
external device.
4. Mode and stimulation level setting – use
setting or for mode setting.
5. Locking of selected function and command – by pushing
continously, the selected button function will be locked. Locked mode is indicated
by this symbol
set only level of a current selected function button. By pressing following symbol
continously you can open transmitter setting again.
TRANSMITTER PREPARATION
on the screen. After you have locked those buttons, you can
.
button you can choose a command
buttons for impulse intensity
shortly
button
27
Advertenties
Hoofdstukken
Inhoudsopgave
