Inhoudsopgave
Advertenties
7
7.1 Battery charging
d-control professional receiver contains the Li-Pol accumulator. The accumulator of
the unit must be charged before using the unit for the first time.
1. Connect the supply cable and the clip to the receiver (see picture)
2. Connect the supply cable to the supply adaptor, afterward plug in the adaptor
into the mains.
3. The orange LED indicator of the receiver will lit up.
4. Charge the acumulator approximately for 2 hours.
5. The orange LED indicator will go out when the charging is finished.
Warning: Rechargeable clip has on the upper and lower jaw small projections,
they must get into the contact with the groove of the receiver.
Optimal temperature for charging is from 0 °C up to 40 °C.
Use only original the power adaptor supplied in the packing with the device.
Other chargers could damage the accumulator.
7.2 Checking the receiver battery status
The status of the battery is indicated by LED indicators on the side of the receiver.
(see chapter: 5.2 Product description – Receiver)
green LED – fully charged accumulator
green and red LED together – accumulator is discharged at 50 %
Red LED – accumulator is discharged
If the accumulator is low of flat, recharge the unit. Do not store the receiver with
discharged accumulator. Could damage the accumulator.
7.3 Switching the receiver ON/OFF
To turn the receiver ON/OFF (or for programming the transmitter with the receiver) is
used a magnetic switch, marked with the red target on the receiver.
Switching ON
1. Move the red target of the transmitter towards the receiver so it comes into the
contact with the red target of the receiver. The red LED indicator of the receiver
will lit up, afterwards the green LED indicator will lit up.
28
RECEIVER PREPARATION
Advertenties
Hoofdstukken
Inhoudsopgave
