Inhoudsopgave
Advertenties
2. When the green LED lighted up, move your
transmitter away from the receiver. The
receiver LED indicator will flash green to
indicate the receiver is ON.
Switching OFF
When switching OFF, follow the same steps as
when switching ON.
1. Move the red target of the transmitter towards
the receiver so it comes into the contact with
the red target of the receiver. The green LED
indicator of the receiver will lit up, afterwards
the red LED indicator will lit up.
2. When the red LED is lighted up, move your
transmitter away from the receiver. The
receiver LED indicators will stop flashing.
Important: When turning the receiver ON/OFF hold the red target of the
receiver close to the red target of the transmitter for about 1 second. When
the targets are close to each other for longer than 5 seconds the receiver will
switch to the pairing (programming) mode of the transmitter with the receiver.
This programming mode is indicated by alternate flashing of the red and green
LED indicator. If this occurs, follow the chapter 7.4 Pairing (programming) the
transmitter with the receiver.
7.4 Pairing (programming) the receiver with the transmitter
Each transmitter has its own radio operational code. The programming of the
transmitter with the receiver enables those two units to work together. When
purchasing new d-control professional set, there is no need to program the device.
The set is programmed from the manufacture. In case you want to use another
transmitter or receiver, you need to program the devices together. Programming
is also necessary for using all four function buttons with one receiver. d-control
professional is compatible with other d-control professional models.
The transmitter is designed for training two dogs, so you can pair it with two
receivers. Function buttons A1/A2 are designed for the dog A and function buttons
B1/B2 for the dog B.
Important: Before the programming make sure no one else is using his d-control
professional or other products from the Dogtrace range close by. Your receiver
could accidentally record the code of his transmitter or interference could
occure. This could someone else transmit some commands into your receiver. If
this occures, program once again the communication of your receiver with your
transmitter.
29
Advertenties
Hoofdstukken
Inhoudsopgave
