Advertenties
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PLONEER authorized service center or your
dealer to carry out repair work.
Symptom
No power supplied to unit.
No sound.
No sound from one speaker.
Can't record tapes.
Can't perform tape copying.
Probable Cause
Power plug is disconnected from outlet.
The component power plug has been plugged
into another
component
power
outlet
(e.g.
timer,
etc.),
but
power
to
that
unit
is
disconnected.
Insert plug securely in outlet.
Turn on power to other component.
Connecting
cords
are
disconnected
from
terminals, or connected incorrectly.
Terminals or connecting cords pin plugs are
dirty.
The MUTING switch is set to ON.
The pressed input selector switch does not
match the desired playback source.
Operation of other components is incorrect.
The
speaker
selector
switches
are
set to
"OFF."
Connecting
cords
or
speaker
wires
are
disconnected on that side.
BALANCE control has been adjusted to one
side (except during DIRECT operation).
The
wrong
REC
SELECTOR
switch
is
pressed.
Connections are incorrect.
Operation of tape deck is incorrect.
The PURE DIRECT LINE switch is set to ON.
Connect securely.
Clean terminals and plugs.
Set the switch to OFF.
Press the correct switch (CD, DAT, PHONO,
TUNER, TAPE, AUX).
Consult the operating instructions for the other
components.
Set one of the switches to "ON."
Connect securely.
Adjust BALANCE contro! to center position.
Press the correct switch.
(See section "RECORDING TAPES.")
Reconnect properly.
Consult the operating instructions for the tape
deck.
Set the switch to OFF.
The wrong REC SELECTOR switch is press.
Operation of tape decks is incorrect.
Press the correct switch.
(See section "COPYING TAPES.")
Consult the operating instructions for the tape
decks.
_ Power cord is connected to a wall outlet, but | Disconnect the power cord and reconnect after a
(No
sound.
Buttons
do _ not | LEDs on the front panel do not light. No sound | few seconds.
function.)
output.
Unit cannot be operated.
15
<ARE1116>
E
:
i
i
:
7
'
i
@
:
:
ESR REIRSON
SSR
EP
E
7ST
BEETS
TE
TTT
STE
EET
FTC
OTS
TS
I CE
ST
nae
RS
TEREST
SRT
Advertenties
