Inhoudsopgave
Advertenties
WARNING:
unless the handle is fully folded up and set
in one of the applicable height positions.
To adjust the handle height on page
Refer to
13 .
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 30)
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Operation of the bat-
tery
Charging of the bat-
tery
Battery status
The display shows the remaining battery capacity and
if there are problems with the battery. Push the battery
indicator button to get information of the state of charge
of the battery. The warning symbol on the battery is on
when an error has occurred. Refer to
17 .
(Fig. 31)
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are
lit
LED 1, LED 2 are lit
LED 1 is lit
14
Do not operate the product
Do not set the cutting height
Before you use the battery,
Ambient temperature
5 °C - 40 °C
5 °C - 40 °C
Battery on page
Battery status
Fully charged (76-100%)
The battery is 51%-75%
charged
The battery is 26%-50%
charged
The battery is 6%-25%
charged.
LED lights
LED 1 flashes
To charge the battery
Charge the battery before the first use. The battery is
only 30% charged when supplied to the customer.
Note:
The battery charger must be connected to the
voltage and frequency specified on the rating plate.
The battery does not charge if the battery temperature
is above 50°C. The battery charger decreases the
temperature of the battery before it starts to charge.
1. Connect one end of the power cord for the battery
charger into the socket of the battery charger.
2. Connect the other end of the power cord for the
battery charger in an grounded mains socket. The
LED on the battery charger flashes green one time.
(Fig. 32)
3. Put the battery in the battery charger. The green
light on the charger comes on when the battery is
correctly connected to the battery charger. (Fig. 33)
4. When all LEDs on the battery have come on the
battery is fully charged. Charge the battery for
maximum 24 hours.
5. To disconnect the battery charger from the mains
socket, pull the plug, not the power cord.
6. Remove the battery from the battery charger.
To start the product
1. Open the battery lid.
2. Put a charged battery in the battery holder.
3. Turn the safety key to 1. (Fig. 34)
4. Stay behind the product.
5. Loosen the start inhibitor. (Fig. 18)
6. Push the motor brake handle in the direction of the
handlebar. (Fig. 35)
To use the SavE
The product has a battery saving function (SavE
gives longer operation time.
™
•
Push the SavE
button to position 1 to start the
function. (Fig. 36)
™
•
Push the SavE
button to position 0 to stop the
function.
Note:
™
The SavE
function stops automatically if the
ground conditions make it necessary to have a higher
™
output. The SavE
function starts automatically again
when the ground conditions let it.
Battery status
The battery is 0%-5%
charged.
™
function
1574 - 011 - 22.08.2023
™
) that
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
