Inhoudsopgave
Advertenties
4
Installation
A
Read the "Safety Instructions" section first!
4.1. Appropriate Installation Location
Contact an Authorized Service for the
installation of the product. In order to prepare
the product for use, refer the information in
the user manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified electrician
and technician to have any necessary
arrangements carried out.
WARNING: Manufacturer shall not be
B
held liable for damages that may arise
from procedures carried out by
unauthorized persons.
WARNING: Product must not be plugged
B
in during installation. Otherwise, there
is the risk of death or serious injury!
WARNING: If the door clearance of the
room where the product shall be place
is so tight to prevent passing of the
A
product, remove the door of the room
and pass the product through the door
by turning it to its side; if this does not
work, contact the authorized service.
•
Place the product on an even floor surface
to prevent jolts.
•
Install the product at least 30 cm awayfrom
heat sources such as hobs, heater cores
and stoves and at least 5 cm away from
electrical ovens.
•
Product must not be subjected to direct
sun light and kept in humid places.
•
Appropriate air ventilation must be
provided around your product in order to
achieve an efficient operation. If the
product is to be placed in a recess in the
wall, pay attention to leave at least 5 cm
distance with the ceiling and side walls.
•
Please provide at least 5cm distance for air
circulation between the back side of your
product and the wall to avoid condensation
on the rear panel of product.
Refrigerator / User manual
•
Your product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls.
•
If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls. Check if the rear
wall clearance protection component is
present at its location (if provided with the
product). If the component is not available,
or if it is lost or fallen, position the product
so that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance at
the rear is important for efficient operation
of the product.
4.2. Adjusting the Feet
If the product stands unbalanced after
installation, adjust the feet on the front by
rotating them to the right or left.
4.3. Elektrische aansluiting
WARNING: Do not make connections
A
via extension cables or multi-plugs.
WARNING: Damaged power cable
B
must be replaced by the Authorized
Service Agent.
If two coolers are to be installed side
C
by side, there should be at least 4 cm
distance between them.
•
Our company shall not be liable for any
damages that will arise when the product is
used without grounding and electrical
connection in accordance with the national
regulations.
09 / 18 EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
