Inhoudsopgave
Advertenties
Adjustment of the headband Professional L (see Fig. 4): To adjust for the head size,
the headband can be widened or tightened by turning the turnbuckles at the top (1)
and the back. (2).
Adjustment of the headband Lightweight (see Fig. 5): To adjust the head size, the
headband can be widened by pressing the lever (1) and tightened by pulling at the
free end (2).
2
3
Fig. 4 Headband Professional L (see tall fig.),
optical protection cover (see small fig.)
ML4 LED, fitting the headband rheostat
You can fit the headband rheostat (1) either on the left or the right side of the headband
(see Fig. 6). The headband rheostat (1) can then be used for stepless adjustment of the
brightness.
When using the ML4 LED, it is recommended that the mPack rheostat is set to „0" .
Fig. 6 Fitting the headband rheostat
3
10/76
1
4
2
1
MED 113192
5
Fig. 5 Headband Lightweight
1
1
How to fit the LoupeLight 2 to the binocular
loupe mount with i-View
Unscrew the screw (1) on the light mount (2) so
that this can be attached to the round attachment
of the loupe mount (3). The LoupeLight 2 housing
has to fit between the eyepieces (not above them!).
The cable of the LoupeLight 2 can be affixed on
the right or left side piece of spectacles using the
cable clips. The enclosed coloured retention clips
are designed for personalisation and labelling of
the loupe light.
Fig. 7 Fitting the LoupeLight 2 with i-View
2017-01-19
1
(Fig. 7):
®
®
2
Advertenties
Inhoudsopgave
