Inhoudsopgave
Advertenties
Installation
•
When making connections to the vehicle's electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads to
provide power for this unit. When connecting the X800D
to the fuse box, make sure the fuse for the intended
circuit of the X800D has the appropriate amperage.
Failure to do so may result in damage to the unit and/or
the vehicle. When in doubt, consult your dealer.
•
The Display must be completely retracted in the casing
when installing. If it is not, problems may occur.
1
Before installing, make sure that the
opening and closing of the display will not
interfere with operation of the gear shift.
Movable Display
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
X800D
•
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold
separately).
•
The diagram and the fuse amperage shown above are in the case when X800D is used individually.
•
If the switched power (ignition) lead of the X800D is connected directly to the positive (+) post of the vehicle's battery, the
X800D draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the
battery may be discharged.
12
-EN
All manuals and user guides at all-guides.com
2
ACC
(Red)
BATTERY
(Yellow)
Owner's manual
Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
0 - 30°
SPST SW (Optional)
FUSE (20A)
(Optional)
Battery
Installation
FUSE (5A)
(Optional)
Advertenties
Hoofdstukken
Inhoudsopgave
