Advertenties
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables.
Spare parts, consumables and accessories approved by Hilti for use with the product can be
found at your local Hilti Store or online at: www.hilti.group
Before being dispatched, the product was tested to ensure that it is in full working order. There
workpiece used in testing might have left tiny scratches in the surface of the housing.
Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature
and thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the product's
performance drops noticeably or it might stall completely.
If the product stalls or slows significantly due to overloading, relieve the pressure applied to the
product and then allow it to run under no load for approx. 30 seconds.
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of
health.
Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶
If the release button is pressed with a battery inserted in the product, subsequently check that the
battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is
applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product
is switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
One (1) LED quick-flashes yellow
One (1) LED shows yellow
23
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely discharged.
Recharge the battery.
If the LED again starts quick-flashing after the
battery has been charged, consult Hilti Service.
The Li-ion battery or the product in which it is
inserted is overloaded, too hot or too cold, or
experiencing some other fault.
Bring the product and the battery to the rec-
ommended working temperature and do not
overload the product when it is in use.
If the message persists, consult Hilti Service.
The Li-ion battery and the product in which it
is inserted are not compatible. Consult Hilti
Service.
2327535
*2327535*
Advertenties
