Inhoudsopgave
Advertenties
3- The two minute fi gures will fl ash.
Select using
or
.
Save by pressing
.
1
4- The cursor above the number 1 (which represents the Monday) will
fl ash. Select the date using
Save by pressing
.
1 1
5- To change and/or allocate programmes press
ting the time and day mode, press
Choices programmes
Schematic sequence of programmes:
Auto
Comfort
Version with occupancy detector: The device is delivered by default with
the self-learning mode enabled as described
suits your requirements, you have nothing more to do, the device, after
the initial 7 day learning period will follow the autoprogramme which
will continue to tailor itself to your occupancy cycles.
Other version: your device's default setting is non-stop Comfort for 7
days a week.
Programmes overview
- Auto: Auto-programming (See Automatic programming with selfl ear-
ning process
page
10).
- Comfort: your device will operate in Comfort mode, 24 hours a day, as
regards each day selected.
Note: You can set the Comfort mode temperature to the temperature
you require
(see the Setting the Comfort mode temperature section
page
5).
- Eco: The device will operate 24 hours a day in Eco mode.
Note: You can set the temperature-lowering parameters
- P1: your device will operate in Comfort mode from 06:00 to 22:00 (and
in Eco mode from 22:00 to 06:00).
- P2: your device will operate in Comfort mode from 06:00 to 09:00 and
from 16:00 to 22:00 (and in Eco mode from 09:00 to 16:00 and from
22:00 to 06:00).
- P3: your device will operate in Comfort mode from 06:00 to 08:00, from
12:00 to 14:00 and from 18:00 to 23:00 (and in Eco mode from 23:00
to 06:00, from 08:00 to 12:00 and from 14:00 to 18:00).
Potential modifi cations of programmes
If the default time schedules for the P1, P2 and P3 programmes does not
suit your routines, you can change them.
Modifying the P1, P2 or P3 programmes.
If you modify the time schedules for the P1, P2 or P3 programmes,
the schedules will be modifi ed for all the days of the week for which P1,
P2 or P3 had been set.
1
or
.
1
2
. To exit the set-
3 times.
Eco
P1
P2
on page
6. If this programme
(see page
1- If you just set the time and day, go to step 2.
From Auto, Comfort, Eco or Frost protection mode, press
seconds.
When the cursor moves above the setting time symbol
shortly.
2
2- Press
or
3- With
or
P1 will fl ash. Press
P3
4- The P1 start time (which by default is 06:00) will fl ash.
Using
or
minutes.
14).
Save by pressing
5- The P1 end time (which by default is 22:00) will fl ash. Using
, you can change this time, by increments of 30 minutes.
Save by pressing
1
. The cursor moves above prog.
1 1
, select P1.
for 5 seconds to make changes.
1 1
1
, you can change this time, by increments of 30
1
.
1
.
M16MI328 A02_01/18
EN
for 5
, press
2
5 sec.
2
or
2
7
Advertenties
Hoofdstukken
Inhoudsopgave
